How To Install No Drill Fender Flares

Pace ane: Install Fender Flare Trim

Fit trim over the edge of the flare and remove the red adhesive record as you go along.

Stride 2: Attach Outer Bolts

Make certain polish edge of the washer hits the pigment. Tighten down the nyloc nut using included Allen tool to hold bolt in place.

Pace 3: Remove Factory Screws From Fender Well

These 3 screws are located forth the edge of the fender well. On this 2022 F-150, they are 7/32-inch screws.

Pace 4: Install Flare Bracket

The bracket should align with ii of the removed screws. Reinstall top ii vii/32nd screws and attach provided U-Prune to hold bracket in place.

Footstep 5: Examination-Fit Fender Flare

With flare in place, mark bottom fender flare hole where information technology aligns with the plastic bumper for drilling a 1/four-inch pigsty.

Pace six: Marker Fender Flare for Drilling

Make up one's mind position of the pigsty in the frame relative to the fender flare and mark flare for drilling a 1/4-inch hole.

Drill out the plastic bumper and the marked position on the fender flare.

Footstep 8: Align Fender Flare and Install Hardware

Install included hardware at the newly drilled portions and reinstall the bottom 7/32-inch screws.

Footstep 9: Install Plastic Fasteners

Push in plastic fasteners at the indicated locations to further secure fender flare in place. Some fasteners may not be used on certain applications.

Step 10: Motility to Rear of Vehicle

Remove 10mm support beam bolts from the rear cycle wells.

Step 11: Put Flare in Identify

Loosely reinstall 10mm bolts to hold these in identify.

Footstep 12: Marker Holes

Mark the sheet metallic on the inside of the fender where the holes in the fender flare occur.

Step thirteen: Mark Final Sail Metal Hole

This hole volition require you to move the flare back to mark the proper position.

Step 14: Install U-Clips

U-clip holes should confront toward the tire while the threaded portion should face in toward the body of the vehicle. Loosely install U-Clip bolts.

Pace 15: Tighten Hardware

With U-clips in place, fully tighten all U-Prune bolts and the 10MM support beam bolts.

Stride 16: Repeat Process on Opposite Side

Complete installation process on opposite side of vehicle.

Source: https://realtruck.com/blog/how-to-install-true-edge-fender-flares/

Iklan Atas Artikel